For lower temperatures 30°C - 120°C
Fixed PTFE-tube (6x1, 8x1 or 10x1 mm)

ATEX-APPROVEn

Application
This electrical heated AHLX0xx0-PA sample tube is designed to transport sample gas through an explosive zone type 1 op 2, but not zones type 0. They can be connected to all Ankersmid sample elements. They are used to keep the necessary gas components above their ACID-dew point, and avoid condensation.

This is a safe way to transport the sample to a heated analyser or the special Ankersmid coolers.

Description

These AHLX0xx0-PA heated lines are manufactured according to the clients needs and completely confectioned in the factory at a fixed length.

The sample line is standard equipped with a PT100 for temperature control. The heater used in this type is ONE serial resistance, twisted around the tube. Due to this construction we can not have cold zones or spots, where a potential blockage can occur.

With flexible isolation out of multi-layer glass wool
A variety of standard lines is available but many options can be supplied as well.
Ready-to-use with multi-pole connector. This heated sample tube is ready-to-use and a stainless steel stud on each tip makes connection easy.

See our folder Chpt. 2.1.1 for all versions. 

• Completely manufactured “ready-to-use”
• ONE serial heater
• Never cold spots
• Tube 4/6, 6/8 or 8/10 mm
• PTFE-tube fixed
• Max. available length 48 meter
• 2 sensors PT100 are incorporated at 300 mm from the tip of the line
• The electric cables are 1,5 meter, to be used only with ATEX-approved temperature controller and limiter

·         CE-certified under no. EX5 07 10 29587 004 

Documentation

General terms of delivery 2024 ENG

Algemene leveringsvoorwaarden 2024

Contaminatie verklaring